© 2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information.
Page 35 of 39
Mod MAC-Address(es) Serial-Num
--- -------------------------------------- ----------
1 00-19-07-6c-5a-a8 to 00-19-07-6c-62-a8 NA
2 00-19-07-6c-5a-a8 to 00-19-07-6c-62-a8 NA
Mod Server-IP Server-UUID Server-Name
--- --------------- ------------------------------------ --------------------
1 10.29.172.188 NA NA
2 10.29.172.188 NA NA
*
this terminal session
The Cisco Nexus 1000V Series has been set up in Layer 3 mode. You can verify this setup by running the
following command:
VSM-1110# show svs domain
SVS domain config:
Domain id: 56
Control vlan: NA
Packet vlan: NA
L2/L3 Control mode: L3
L3 control interface: mgmt0
Status: Config not pushed to VC.
Control type multicast: No
Complete the Cisco Nexus 1000V Series Installation
To complete the installation of the Cisco Nexus 1000V Series, the VSM needs to be registered with VMware
vCenter, and the VEM needs to be installed on the hosts. To complete these actions, you can use the Cisco Nexus
1000V Series Installer App utility. The Installer App utility is bundled in the cisco Nexus 1000V Series image zip
file. After the zip file has been extracted, the Installer App utility can be found in the following directory:
Nexus1000v.4.2.1.SV2.1.1/VSM/Installer_App/Nexus1000V-install_CNX.jar
You can invoke the Installer App utility from the command line using
java -jar Nexus1000V-install_CNX.jar
.
To register the Cisco Nexus 1000V Series VSM, select the
vCenter Server Connection
button and then click
Next
(Figure 23).
