To connect a terminal to the EIA Console port on the chassis, follow these steps:
Step 1
Connect the USB end of the USB-to RJ-45 cable to the EIA Console port.
Step 2
Connect the RJ-45 end of the DB-9 adapter cable to the USB-to RJ-45 cable, as shown in figure below.
Figure 27: Connecting a Modem to the Cisco NCS 4201
Table 2:
Component
Label
Component
Label
RJ-45 to DB-9 cable
3
EIA Console port
1
Desktop or system
4
USB-to-RJ-45 adapter
2
Step 3
Connect the DB-9 end of the console cable to the DB-9 end of the terminal.
Step 4
To communicate with the chassis, start a terminal emulator application, such as Microsoft Windows HyperTerminal.
This software should be configured with the following parameters:
•
9600 baud
•
8 data bits
•
no parity
•
1 stop-bit
•
no flow control
Cisco NCS 4201 Hardware Installation Guide
38
Installing the Cisco NCS 4201
Connecting to the EIA Console Port
