Cisco Linksys X1000, User Manual

Page: 159 / 678

4
Installation
Linksys X1000
b.
Connect the gray cable to the modem-router’s
DSL
port and to a
telephone jack on your wall, then click
Next
.
You are asked to enter your ISP information .
c.
Select your region, click
Next
, then select your ISP . If prompted, enter
your DSL account name and password .
Or, to skip the automatic detection of your region and manually
configure your Internet connection, select
My region is not in this
list
, then click
Next
. Use information available from your ISP to
complete the remaining screens for DSL settings, Internet type, and
account information .
d.
Follow the on-screen instructions to finish the setup .
Set up your modem-router manually
NOTE
Run the Setup CD-ROM to install the modem-router . If you cannot
run the Setup CD-ROM, refer to the steps below .
NOTE
If you are setting up your modem-router in New Zealand, see
“NOTE FOR USERS IN NEW ZEALAND” on page 6 .
Connect your modem-router
To connect your modem-router:
1.
Power down all your network devices, including your computer(s) and
the modem-router . If you currently use a modem, disconnect it now—
the modem-router replaces your modem .
2. Connect one end of the provided Ethernet cable to your computer’s
Ethernet adapter and the other end to an Ethernet port on the back of
the modem-router .
3. Repeat step 2 for each additional computer or device that you want to
connect to the modem-router .
NOTE
If your computer’s Ethernet adapter is not set up, refer to the
Ethernet adapter’s documentation for more information .
4. Connect one end of the phone cable to the DSL port on the back .