Cisco Linksys NMH300, Quick Installation Manual

Page: 5 / 232

Media Hub
English
1
English
IMPORTANT:
You must have a 3 .5-inch, Serial-ATA (SATA) hard disk
drive available to install in the Media Hub .
You can use a new or previously used hard disk drive . If you use a previously used
hard disk drive, all data on that drive will be erased during installation . If you want to
keep any of the data, back up the drive before installation of the Media Hub .
The
Installation section explains how to install the Media Hub and set up your
computer for access to the Media Hub . For a Windows computer, proceed to the
Windows Installation section . For a Mac, proceed to the Mac Installation section .
The Setup of Additional Computers section explains how to set up additional
computers for access to the Media Hub . The Tools section describes different ways to
take advantage of the Media Hub’s features .
Windows Installation
NOTE:
The Media Hub Setup Wizard installs several programs that
enhance the functionality of the product . Software firewalls installed on
your computer can block this communication between the programs
and the Media Hub . It is strongly recommended that you disable your
firewall software prior to installation of the Media Hub .
1.
Make sure the Media Hub is
powered off .
Insert the Setup Wizard CD-ROM
into your computer’s CD-ROM
drive . The Setup Wizard should run
automatically, and the video should
begin automatically . If it does not,
click Start and then Run . In the
field provided, enter D:\startinstall.
exe (if “D” is the letter of your CD-
ROM drive) .
2.
An introductory video plays . To bypass the video, click the X button in the
upper right corner of the screen .