For More Information
• For a list of copper SFPs, see
Supported SFP/SFP+ Transceivers, on page 31
1-Gb Network Module
The following figure shows the front panel of the 1-Gb network module (FPR2K-NM-8X1G). The
FPR2K-NM-8X1G is a single-wide module that supports hot swapping. The eight ports are numbered from
top to bottom, left to right.
Make sure you have the correct firmware package and software version installed to support this network
module. See
Cisco FXOS Troubleshooting Guide for the Firepower 1000/2100 with Firepower Threat Defense
for the procedure to verify your firmware package and software version. See
Platform Mode FXOS Configuration Guide
for the procedure to upgrade the firmware package for the Firepower
2100 running ASA with FXOS. See the
Cisco Firepower Compatibility Guide
and the
guide, which provide Cisco software and hardware compatibility, including operating system and hosting
environment requirements, for each supported version
Note
The FPR2K-NM-8X1G is NEBS-compliant.
Note
You can fit four copper SFPs in either the top row of ports or the bottom row of ports. Both rows cannot be
populated at the same time, because of the port row spacing.
Note
Figure 16: FPR2K-NM-8X1G
Ethernet
X
/1
2
Captive screw/handle
1
Ethernet
X
/5
4
Ethernet
X
/3
3
Ethernet
X
/2
6
Ethernet
X
/7
5
Cisco Firepower 2100 Series Hardware Installation Guide
21
Overview
1-Gb Network Module
