7-4
Cisco 1120 Connected Grid Router Hardware Installation Guide
OL-26438-02
Chapter 7 About Connected Grid Modules
Where to Find Additional Module Information
Remove Modules
To remove a module from the router:
Step 1
Power down the router as described in the router hardware installation guide on Cisco.com, at:
www.cisco.com/go/cgr1000-docs.
Step 2
Insert the module in the slot as shown in
Figure 7-1
.
Step 3
Using a screwdriver to loosen the module captive screws (two per module) from the connectors on the
router front panel.
Step 4
Use your hands to gently pull the module from the router.
Step 5
If needed, power on the router as described in the router hardware installation guide on Cisco.com, at:
www.cisco.com/go/cgr1000-docs.
Where to Find Additional Module Information
For instructions on how to install, replace, and configure the modules, see these installation and
configuration guides on Cisco.com, at:
www.cisco.com/go/cg-modules
Item
Description
1
Module captive screws, 2 per module
2
Router captive screw connectors (4)
Table 7-1
Connected Grid Modules for CGR 1000 Series Routers Documentation
Connected Grid Module
Related Documentation
Cisco Connected Grid Modules for
CGR 1000 Series – WiMax
Cisco Connected Grid WiMAX Module for CGR 1000
Series Installation and Configuration Guide
Cisco Connected Grid Modules for
CGR 1000 Series – Cellular 3G
Cisco Connected Grid Cellular 3G Module for CGR 1000
Series Installation and Configuration Guide
Cisco Connected Grid Modules for
CGR 1000 Series – WPAN
Cisco Connected Grid WPAN Module for CGR1000 Series
Installation and Configuration Guide
