![background image](http://html.mh-extra.com/html/cisco/evm-ipvs-16a/evm-ipvs-16a_connecting_64919009.webp)
Connecting Cisco Analog Video Gateway Network Modules to the Network
How to Install, Connect, or Replace the EVM-IPVS-16A Network Module
9
Connecting Cisco Analog Video Gateway Network Modules to the Network
Figure 5
Connecting the Video Breakout Cable to the EVM-IPVS-16A Network Module
Warning
Equipment connected to outdoor cameras must be permanently grounded in accordance with national
and local codes.
Statement 374
Step 2
Connect the BNC ends of the video breakout cable to the cameras in your network. The cable ends are
labeled with the corresponding port number (0-15).
Step 3
After you have wired the provided terminal block connectors according to the pinout information
provided in
Table 4
, connect the terminal block connectors to the terminal block on the EVM-IPVS-16A
network module and tighten the screws using a small slotted screwdriver.
Figure 6
Connecting the Terminal Block Connectors to the EVM-IPVS-16A Network Module
230459
230460