![background image](http://html.mh-extra.com/html/cisco/evm-ipvs-16a/evm-ipvs-16a_connecting_64919006.webp)
Connecting Cisco Analog Video Gateway Network Modules to the Network
How to Install, Connect, or Replace the EVM-IPVS-16A Network Module
6
Connecting Cisco Analog Video Gateway Network Modules to the Network
•
Performing Online Insertion and Removal of the EVM-IPVS-16A Network Module, page 10
Installing the EVM-IPVS-16A Network Module in the Router Chassis
To install the EVM-IPVS-16A network module in the router chassis, see the
Installing Cisco Network
Modules in Cisco Access Routers
guide at:
http://www.cisco.com/en/US/docs/routers/access/interfaces/nm/hardware/installation/guide/InstNetM.
html
Note
The EVM-IPVS-16A network module can only be installed in slots that support extension modules. For
information about which slots support extension modules, see
Table 1-1 on page 5
Wiring the Terminal Block Connectors
Wire the provided terminal block connectors using the pinout information provided in
Table 4
. (See
Figure 4
.)
Note
The wires used to connect to the terminal block are required to be between 26 AWG and 18 AWG.
Figure 4
Wiring the Terminal Block Connectors
Table 4
lists each pin on the terminal block, and the corresponding port information.
Tip
When you wire the terminal block connector, label each wire with the pin number, so you can easily
connect the wires to the alarm or RS-485 devices in your network.
230462