15
Cisco 10-Gigabit Ethernet XENPAK Transceiver Modules Installation Note
78-15665-07
Removing the XENPAK Transceiver
Figure 3
Cabling an Optical XENPAK Transceiver Module
Figure 4
Cabling a CX4 (Copper) XENPAK Transceiver Module
Removing the XENPAK Transceiver
Caution
The 10-Gigabit XENPAK transceiver is a static-sensitive device. Always use an ESD wrist strap or
similar individual grounding device when handling the XENPAK transceivers or coming into contact
with the modules.
If you are removing a 10-Gigabit XENPAK transceiver, follow these steps:
Step 1
Disconnect the network fiber-optic cable from the 10-Gigabit XENPAK transceiver connectors.
Immediately reinstall the dust plugs in the XENPAK transceiver optical bores and the fiber-optic cable
SC connectors.
Step 2
Loosen the two captive installation screws that secure the XENPAK to the module.
1
LINK
LINK
ACTIVE
2
130145
RX
TX
Network interface
cable
SC connector
XENPAK
130146
4X InfiniBand
connector
CAB-INF-28G-5
XENPAK-10GB-CX4
