2-5
Cisco Video Surveillance 2611 IP Dome User Guide
OL-24128-02
Chapter 2 Getting Started
Installing the Cisco Video Surveillance 2611 IP Dome
Step 4
Remove the ceiling tile from the location at which you want to mount the IP dome and cut a 6-1/2 inch
(16.5 cm) diameter hole in the center of the tile.
Step 5
Place the camera housing through the hole that you cut in the ceiling tile.
Orient the camera housing so that the anchor clips face away from the bottom of the dome (see
Figure 2-3
).
Step 6
Place the ceiling tile mount over the camera housing.
Orient the ceiling tile mount so that it is flush with the back surface of the ceiling tile (see
Figure 2-3
).
Step 7
Use a Phillips-head screwdriver to turn the anchor screws clockwise and spin the anchor clips outward
into the locking position and to secure the anchor clips.
The anchor clips twist over the ceiling and the ceiling tile mount. Turn the anchor clip screws until the
camera housing is snug against the ceiling tile. Do not over tighten the screws.
Figure 2-3
Placing the 2611 IP Dome in a Ceiling Tile
Step 8
Put the an category 5 or higher Ethernet cable through the camera housing and connect it to the LAN
port on the IP dome (see
Figure 1-1 on page 1-3
).
1
Camera housing
2
Camera unit
2
Camera unit screws
4
Privacy shield
5
Dome and trim ring assembly
1
Ceiling tile mount
2
Camera housing
3
Ceiling tile
4
Anchor clips
