Cisco CISCO7206, Quick Start Manual

Page: 7 / 32

7
3
Rack-Mount the Router
Brackets Front-Mounted—Chassis Protrudes from the Rack
Locate the rack-mount and cable-management brackets and screws (1, 2, 3 in the illustration above) and a Number 2 Phillips
screwdriver.
1.
Align the rack-mount bracket (1)—as shown above—to the side of the router. Insert and tighten the screws (3) if you are
not adding the cable-management brackets. Repeat this step on the other side of the router.
Go to the “Two-Post or Four-Post Rack Installation” section on page 10.
2.
If you are using the cable-management brackets, align the rack-mount bracket (1) to the side of the router, align the
cable-management bracket (2) over the rack-mount bracket—as shown above—and insert the screws (3) through both.
Tighten the screws. Repeat this step on the other side of the router.
Go to the “Two-Post or Four-Post Rack Installation” section on page 10.
1
Rack-mount bracket
3
M4 x 8-mm Phillips flathead screws
2
Cable-management bracket
53498
2
ETHERNET-10BFL
EN
RX
0 1
2 3
4
TX RX TX
RX TX RX TX RX
TX
ETHERNET 10BT
ENABLED
0 2
1 3
LINK
0 1 2 3
0
4
1
3
5
6
FAST SERIAL
EN
TD TC RD RC LB CD TD TC RD
RC LB CD TD TC RD RC LB CD TD
TC RD RC LB CD
ENABLED
MII LINK RJ45
FAST ETHERNET
0
TOKEN RING
0 1
2 3
ENABLED
IN-RING
4/16 Mbps
Cisco 7200
Series
FAST ETHERNET INPUT/OUTPUT CONTROLLER
ENABLED PCMCIA
EJECT SLOT 0
FE
ENABLEFE LINK
CPU RESET 1O POWER
OK
SLOT 1
FE MII
1
2
3