Cisco CGR 1240, Mounting Instructions

Page: 14 / 26

62
Install the Router onto the Mounting Bracket
This section describes how to attach the router to the mounting bracket. The mounting bracket is installed on the
mounting plate (included in the Cisco pole mount kit), which is installed on a supported pole type. See
Pole Mount Kit,
page 50 .
The instructions for the procedures in this section refer to the mounting bracket kit contents shown in Figure 24 on
page 52 and the bracket features described in Figure 33 on page 60 .
Note: Refer to Install the Optional Security Panel, page 63 for how to install the optional security panel on the bracket.
Figure 35 Router Installed in Mounting Bracket
Required Materials

Mounting bracket and hardware included in Mounting Bracket Kit, page 51 .

Socket wrench that you supply.
To mount the router on the bracket (refer to Figure 36 on page 63 and Figure 37 on page 63 :
1. Assemble eight sets of bracket hardware (washer, split lock washer, and bolt) as shown in Assemble Bracket
Hardware, page 59 .
2. Attach one set of hinge bolt hardware to the mounting bracket connector shown in Figure 37 on page 63 ( 1 ).
Do not tighten the hardware until Step 6. There must be enough space between the washer and the router to slide
the router onto the bracket.
3. Repeat Step 2 on the other side of the router.
4. Slide the router onto the bracket by inserting the hinge bolts you attached in Step 2 into the bracket quick hang slots
(
2 ).
300614