Cisco CGR 1240, Mounting Instructions

Page: 7 / 26

55

Install the Mounting Plate—Through-Pole Mounting (Optional), page 58
Figure 27 Mounting Plate Details
Install the Mounting Plate—Poles Up to 4.5 Inches in Diameter
Required Materials

Mounting plate, carriage bolts, and clamp brackets included in Pole Mount Kit, page 50 .

13-mm box-end socket wrench
To install the mounting plate on a vertical pole up to 4.5 inches (11.4 cm) in diameter (refer to Figure 28 on page 56 and
Figure 29 on page 57 :
1. Select a mounting location on the pole and place the top and bottom pole clamp bracket (1) notches against the
pole.
2. Place one of the clamp brackets on the opposite side of the pole, aligning the clamp bracket holes with the top two
carriage bolt holes on the mounting plate.
3. Insert a carriage bolt ( 5 ) through each of the top two carriage bolt holes on the mounting plate and through the holes
in the clamp brackets.
4. Position the each bolt in the clamp so that the bolt is next to the pole, as shown in Figure 28 on page 56 .
5. To place the bracket hardware on each carriage bolt (see Figure 28 on page 56 ):
Item Description Qty.
1 Carriage bolt holes 4
2 Bracket mount holes 8
3 Clearance holes, 3/4 in. 2
4 Pole clamp notches 2
5 Steel band strap slots 4
300606
1
5
4
4
2
3
Reverse angle