C-8
Catalyst 2360 Switch Hardware Installation Guide
OL-22150-02
Appendix C Configuring the Switch with the CLI-Based Setup Program
Entering the Initial Configuration Information
management network from the above interface summary:
vlan1
Step 8
Configure the interface by entering the switch IP address and subnet mask and pressing
Return
. The IP
address and subnet masks shown are examples.
Configuring interface vlan1:
Configure IP on this interface? [yes]:
yes
IP address for this interface:
10.4.120.106
Subnet mask for this interface [255.0.0.0]:
255.0.0.0
Step 9
Enter
Y
to configure the switch as the cluster command switch. Enter
N
to configure it as a member
switch or as a standalone switch.
If you enter
N
, the switch appears as a candidate switch in the Network Assistant GUI. You can configure
the switch as a command switch later through the CLI, the device manager, or the Network Assistant
application. To configure it later, enter
no
.
Would you like to enable as a cluster command switch? [yes/no]:
no
You have now completed the initial configuration of the switch and the switch. This is an example of the
configuration output that appears:
The following configuration command script was created:
hostname switch1
enable secret 5 $1$Ulq8$DlA/OiaEbl90WcBPd9cOn1
enable password
enable_password
line vty 0 15
password
terminal-password
no snmp-server
!
no ip routing
!
interface Vlan1
no shutdown
ip address 10.4.120.106 255.0.0.0
!
interface GigabitEthernet1/0/1
!
interface GigabitEthernet1/0/2
interface GigabitEthernet1/0/3
!
...<output abbreviated>
!
interface GigabitEthernet1/0/23
!
end
Step 10
These choices appear:
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
Choose (2) to save the configuration to NVRAM to use it the next time the switch reboots.
Enter your selection [2]:
2
