Mod MAC−Address(es) Hw Fw Sw
—— ————————————————————————————————————— ———— ——————— ——————————————————
1 00−50−bd−a0−b0−00 to 00−50−bd−a0−b3−ff 2.0 3.1.2 5.5(2)
2 00−50−0f−b7−ff−50 to 00−50−0f−b7−ff−67 3.1 4.3(1) 5.5(2)
Mod Sub−Type Sub−Model Sub−Serial Sub−Hw
—— ———————— ————————— —————————— ——————
1 NFFC WS−F5521 0011455134 1.1
Catalyst5000> (enable)
One Cisco 1912EN using version 9 of the Catalyst IOS, as shown here (1924EN, 2822, or 2828 are
great Access layer substitutes with Enterprise Network Edition of the CLI−based IOS):
•
1912EN#show version
Cisco Catalyst 1900/2820 Enterprise Edition Software
Version V9.00.00
Copyright (c) Cisco Systems, Inc. 1993−1999
1912EN uptime is 9day(s) 10hour(s) 26minute(s) 36second(s)
Cisco Catalyst 1900 (486sxl) processor with 2048K/1024K bytes of memory
Hardware board revision is 5
Upgrade Status: No upgrade currently in progress.
Config File Status: No configuration upload/download is in progress
15 Fixed Ethernet/IEEE 802.3 interface(s)
Base Ethernet Address: 00−30−80−54−6C−00
One Cisco 2600 router. (Any Cisco router from the 2600 series through the 7000 series will work fine
as a substitute as long as it has at least two 10/100 Ethernet ports. A 10Mbps attachment unit interface
[AUI] port will not work, because Inter−Switch Link [ISL] needs to use a 100BaseTX port for
optimum trunking support.)
•
Note For this lab, the Cisco 2620 series router has been previously configured with its basic configuration.
Two Ethernet crossover cables to run between devices.
•
One console cable and connector.
•
Lab Objectives
During this lab, you will complete the following tasks:
Configure the basic switch configuration on the Cisco 1912EN. Configure the basic passwords, the
hostname, and IP information. Set up three VLANs: VLAN 2, named CAD; VLAN 3, named
Graphics; and VLAN 4, named DocProduction.
•
Configure the basic switch configuration on the Cisco Catalyst 5000. Configure the basic passwords,
the hostname, and IP information.
•
Enable trunking on port f0/27 on the 1912EN to trunk to port 2/2 on the Cisco Catalyst 5000 using
Dynamic ISL (DISL) on the 1912EN side and ISL on the Catalyst 5000 side.
•
Create a trunk port on the Catalyst 5000 port 2/24 to the Fast Ethernet 0/2 interface on the 2600 router
using ISL.
•
Enable a VLAN Trunking Protocol (VTP) domain named Coriolis. Make the 1912EN a VTP server
and the Catalyst 5000 a client in order to propagate the 1912EN’s VLAN configuration.
•
The diagram shown in Figure D.1 illustrates the configuration.
354
Summary of Contents for Catalyst 1900 Series
Page 1: ......
