Step 3
Install the four M6x12mm zinc-plated steel screws through the holes in the bracket and into the threaded holes in the
equipment rack posts.
Step 4
Use a tape measure and level to verify that the chassis is installed straight and level.
Attaching the Cable Guides
The Cisco ASR-920-24SZ-IM Router supports the following cable guides:
•
A920-CBL-GUIDE (left and right)
—
help in routing the cables from all components on the front panel
thereby enabling a proper cable-bending radius.
If the chassis is mounted using 19-inch brackets, you must assemble the cable guides before installing the
chassis on the rack.
Note
To install the cable guides, perform these steps:
SUMMARY STEPS
1.
Position the cable guide-left and cable guide-right against the front of the chassis and align the four screw
holes, as shown in the figure for 19-inch rack and in the figure for other racks using standard kit.
2.
Secure the cable guides with the four M6x12mm screws supplied with the cable kit. The recommended
maximum torque is 3N-m.
Cisco ASR-920-24SZ-IM, ASR-920-24SZ-M, ASR-920-24TZ-M Aggregation Services Router Hardware Installation
Guide
59
Installing the Router
Attaching the Cable Guides
