Cisco Aironet 700W Series, Getting Started Manual

Page: 5 / 31

5
4
Unpacking
To unpack the access point, follow these steps:
Step 1
Unpack and remove the access point and the accessory kit from the shipping box.
Step 2 Return any packing material to the shipping container and save it for future use.
Step 3 Verify that you have received the items listed below. If any item is missing or damaged, contact your Cisco representative
or reseller for instructions.
•
The access point
• Mounting bracket
• Mounting screws
•
Tamper resistant screw
•
Mylar label for tamper resistant screw
5
Configurations
The 700W series access point contains two simultaneous dual-band radios, the 2.4 GHz and 5 GHz 802.11n MIMO radios, in
a controller-based mode.
The 700W series access point configuration is AIR-CAP702W- x -K9—two 2.4 GHz/5 GHz dual-band radios, with two
integrated dual-band antennas.
For information on the regulatory domains (shown as “ x ” in the model numbers) see “Regulatory Domains” section on page 5 .
Internal Antennas
The 700W series access points are configured with two dual-band antennas (two 2.4 GHz and two 5 GHz). The two antennas,
deployed inside the access point, are inside the top housing. The basic features are as follows:
•
Dual-Band antennas.
• Antenna elements integrated into 700W access point top housing.
• Peak gains are approximately 2 dBi in the 2.4 GHz band and 4 dBi in the 5 GHz band.
Regulatory Domains
The 700W series supports the following regulatory domains (shown as “ x ” in the model numbers):
•
-A, -C, -D, -E, -H, -I, -K, -N, -Q, -R, -S, -T, -Z
Countries Supported
Click this URL to browse to a list of countries and regulatory domains supported by the 700W:
www.cisco.com/go/aironet/compliance
6
Access Point Ports and Connectors
The 700W series access points have integrated antennas and do not have external connectors on the top of the unit. In addition
to the integrated antennas the 700W series access points has the following interfaces and connectors:
•
LED