Cisco Aironet 1800s, Getting Started Manual

Page: 25 / 42

25
Using the Reset Button
Using the Reset button (see Figure 2 ) you can:
• Reset the network sensor to it’s default factory-shipped configuration.
• Clear the network sensor internal storage, including all configuration files and the regulatory
domain configuration.
To use the Reset button, press, and keep pressed, the Reset button on the network sensor during the
network sensor boot cycle. Wait until the status LED changes to Amber. Then:
• To reset the network sensor to the default factory-shipped configuration, keep the Reset button
pressed for less than 20 seconds. The network sensor configuration files are cleared.
This resets all configuration settings to factory defaults, including passwords, encryption keys, the
IP address, and the SSID.
• To clear the network sensor internal storage, including all configuration files and the regulatory
domain configuration, keep the Reset button pressed for more than 20 seconds, but less than 60
seconds.
The network sensor status LED changes from Amber to Red, and all the files in the network sensor
storage directory are cleared.
If you keep the Reset button pressed for more than 60 seconds, the Reset button is assumed faulty and
no changes are made.
10
Related Documentation
All user documentation for the Cisco Aironet 1800s series network sensor is available at the following
URL:
(To be added at CCO/FCS)
For detailed information and guidelines for configuring and deploying your network sensor in a
wireless network, see the
Cisco Wireless LAN Controller Configuration Guide , at the following URL:
(To be added at CCO/FCS)