6-10
Cisco Aironet 1400 Series Wireless Bridge Hardware Installation Guide. OL-4072-03
OL-4072-04
Chapter 6 Troubleshooting
Reloading the Bridge Image
Step 2
Make sure the PC contains the bridge image file (
c1410-k9w7-tar.122-13.JA.tar
) in the TFTP server
folder and the TFTP server is activated. For additional information, refer to the
“Obtaining the Bridge
Image File”
and
“Obtaining the TFTP Server Software”
sections.
Step 3
Connect the PC to the bridge using a Category 5 Ethernet cable.
Step 4
Disconnect the power jack from the power injector.
Step 5
Press and hold the
MODE
button while you reconnect power to the power injector.
Step 6
Hold the
MODE
button until the status LED turns red (approximately 20 to 30 seconds).
Step 7
Wait until the bridge reboots as indicated by all LEDs turning green followed by the Status LED
blinking green.
Step 8
After the bridge reboots, you must reconfigure the bridge by using the Web interface, the Telnet
interface, or IOS commands.
Note
The bridge is configured with the factory default values including the IP address (set to receive an IP
address using DHCP). To obtain the bridge’s new IP address, refer to the
“Using the IP Setup Utility”
section on page 5-9
.
Web Browser Interface
You can also use the Web browser interface to reload the bridge image file. The Web browser interface
supports loading the image file using HTTP or TFTP interfaces.
Note
Your bridge configuration is not changed when using the browser to reload the image file.
Browser HTTP Interface
The HTTP interface enables you to browse to the bridge image file on your PC and download the image
to the bridge. Follow the instructions below to use the HTTP interface:
Step 1
Open your Internet browser. You must use Microsoft Internet Explorer (version 5.x or later) or Netscape
Navigator (version 4.x).
Step 2
Enter the bridge’s IP address in the browser address line and press
Enter
. An Enter Network Password
screen appears.
Step 3
Enter your username in the User Name field.
Step 4
Enter the bridge password in the Password field and press
Enter
. The Summary Status page appears.
Step 5
Click the
System Software
tab and then click
Software Upgrade
. The HTTP Upgrade screen appears.
Step 6
Click
Browse
to locate the image file on your PC.
Step 7
Click
Upload
.
For additional information, click the
Help
icon on the Software Upgrade screen.