31
Cisco Aironet 1300 Series Lightweight Outdoor Access Point Mounting Instructions
78-17634-01
Mounting the Access Point
Mounting the Access Point on a Support
This warning applies to outdoor installations:
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
To attach the access point to a support, follow these steps:
Step 1
Mount the housing bracket to the mounting bracket by sliding the hang pins on the housing bracket into
the hang pin slots on the mounting bracket. The connectors should face downward (See
Figure 13
).
Figure 13
Mounting the Access Point to the Support
Step 2
Secure the housing bracket to the support bracket with four hex bolts and flat washers.
Note
If you are using the integrated antenna, loosely tighten the U bolts so you can adjust the access
point horizontally for antenna positioning.
Step 3
Roughly position the integrated antenna by pointing the flat face of the access point toward the site of
the remote access point.
Step 4
After aligning the antenna, tighten all mounting bolts to 6 to 10 ft-lbs.
1
Hex bolt with serrated flange and washer (4 locations)
117140
1
1
0
15
15
TH
IS
SID
E
UP
