8-8
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
OL-4310-05
Chapter 8 5-GHz Radio Module Upgrade
Finding the Software Version
Step 1
Check the product compliance label to identify the model number of your 1200 series access point.
Step 2
Refer to
Figure 8-6
for the compliance label locations.
Step 3
Use the matrix in
Table 8-1
to decide which labels to use and where to place them on the access point.
Step 4
Discard any labels that you did not use.
The 5-GHz radio module installation is now complete and radio settings are at default values. To
configure the 5-GHz radio with your wireless network settings refer to the
Cisco IOS Software
Configuration Guide for Cisco Aironet Access Points.
Finding the Software Version
To find the version of IOS software running on your access point, use a Telnet session to log into the
access point and enter the
show version
EXEC command. This example shows command output from
an access point running Cisco IOS Release 12.2(11)JA:
ap1200>
show version
Cisco Internetwork Operating System Software
IOS (tm) C1200 Software (C1200-K9W7-M), Version 12.2(11)JA
Copyright (c) 1986-2003 by Cisco Systems, Inc.
On access points running IOS software, you can also find the software version on the System Software
page in the access point's web-browser interface.
If your access point does not run IOS software, the software version appears at the top left of most pages
in the web-browser interface.
Table 8-1
Locations for Compliance Labels
1200 Series
Model
AIR-RM21A-x-K9 or AIR-RM22A-x-K9
Radio Compliance Label
AIR-AP1210-x-K9 Product
Compliance Label
AIR-AP1220A
Place over existing AIR-RM20A-x-K9
radio compliance label or location 3 if no
label exists.
Place over existing product compliance
label.
AIR-AP1230A
All other models
Discard product compliance label.