Chapter 4 Troubleshooting
Getting Started
4-2
Cisco 7609 Internet Router Installation Guide
OL-5079-04
Note
This chapter covers only the chassis component hardware aspects
of troubleshooting. For module-specific information, refer to the
Cisco 7600 Series Internet Router Module Installation Guide
.
Getting Started
When the initial system boot is complete, verify the following:
•
Power supplies are supplying power to the system.
•
The system fan assembly is operating.
•
System software boots successfully.
•
The supervisor engine and all switching modules are installed properly in
their slots, and each was initialized without problems.
If each of these conditions is met and the hardware installation is complete, refer
to the
Cisco 7600 Series Internet Router Software Configuration Guide
, the
Cisco 7600 Series Internet Router IOS Software Configuration Guide
, the
Cisco 7600 Series Internet Router Command Reference
, or the
Cisco 7600 Series
Internet Router IOS Command Reference
publications to troubleshoot the
software. However, if any of these conditions are not met, use the procedures in
this chapter to isolate and, if possible, resolve the problem.
Problem Solving to the System Component Level
The key to success when troubleshooting the system is to isolate the problem to a
specific system component. The first step is to compare what the system
is
doing
to what it
should be doing
. Because a startup problem can usually be attributed to
a single component, it is more efficient to isolate the problem to a subsystem
rather than troubleshoot each separate component in the system.
The switch consists of the following subsystems:
•
Power supply—Includes the power supplies and power supply fans.
•
Fan assembly—The chassis fan assembly should operate whenever system
power is on. You should see the FAN LED turn green and should be able to
hear the fan assembly to determine whether or not it is operating. If the FAN
