17
Start the System (continued)
Last reset from power-on
X.25 software, Version 3.0.0.
2 FastEthernet/IEEE 802.3 interface(s)
2 ATM network interface(s)
125K bytes of non-volatile configuration memory.
8192K bytes of Flash PCMCIA card at slot 1 (Sector size 128K).
8192K bytes of Flash internal SIMM (Sector size 256K).
2
Enter yes or press Return to enter the initial configuration dialog:
--- System Configuration Dialog ---
Would you like to enter the initial configuration dialog? [yes/no]: yes
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Basic management setup configures only enough connectivity
for management of the system, extended setup will ask you
to configure each interface on the system
3
Enter yes or press Return to see the current interface summary:
First, would you like to see the current interface summary? [yes]: yes
Any interface listed with OK? value “NO” does not have a valid configuration
Interface
IP-Address
OK? Method
Status
Protocol
FastEthernet0/0
unassigned
NO
unset
up
up
FastEthernet0/1
unassigned
NO
unset
up
up
ATM1/0
unassigned
NO
unset
down
down
ATM2/0
unassigned
NO
unset
down
down
Note: The example shows a router at first-time startup; that is, nothing is configured. The type
of interfaces vary depending on the type of Cisco 7100 series router you are using and the type
of modular port adapter installed in the router.
Summary of Contents for 7100 Series
Page 2: ......
