Cisco 675E, Hardware Installation Manual, Page: 50 / 104

Chapter 2 Installation
Connecting the RPS 675
2-16
Cisco RPS 675 Redundant Power System Hardware Installation Guide
78-15201-04
Figure 2-6 Connecting the Cable to the RPS 675
Warning
Attach only the Cisco RPS (model PWR675-AC-RPS-N1) to the RPS receptacle.
Statement 100C
Step 3
Connect the other end of the RPS connector cable to the RPS receptacle on
the switch.
Step 4
Repeat Step 2 through Step 3 for each switch that the RPS 675 will support.
Step 5
Connect all supported devices to an AC power source.
Note
The RPS 675 is designed to provide backup for internal power supply
failures of connected device power supplies. It is not designed to act as a
backup power source that protects against losses of power due to external
power outages. We recommend using an uninterruptable power system
(UPS) as protection against power outages.
Step 6
If the RPS is not already connected to AC power, connect the AC power cable to
the RPS 675 as shown in
Figure 2-7 , and connect the other end of the power cable
to an AC power source.
100-240V~
10-6A
50/60Hz
DC OUTPU
T 1
DC OUTPUT
2
DC OUTPUT
3
DC OUTPU
T 4
DC OUTPU
T 5
DC OUTPUT
6
12V /25A, -4
8V /7.8A M
AX OUTPU
T
CAUTION: R
PS NOT HO
T PLUGGA
BLE
86669