Cisco 675E, Hardware Installation Manual, Page: 48 / 104

Chapter 2 Installation
Connecting the RPS 675
2-14
Cisco RPS 675 Redundant Power System Hardware Installation Guide
78-15201-04
Mounting the RPS in a Rack
After the brackets are attached to the RPS, use the four supplied number-12
Phillips machine screws to securely attach the brackets to the rack, as shown in
Figure 2-5 .
Figure 2-5 Mounting the RPS in a Rack
Connecting the RPS 675
Caution
Make sure that the RPS is either in standby mode or that the RPS AC power is
disconnected before you connect the RPS to a switch. This precaution is necessary
because when you connect the RPS to the AC power, the RPS automatically
becomes active.
Note
Do not use different power sources to power up the RPS and the connected device.
If you connect to separate AC power sources, reset conditions might occur.
1 Phillips machine screws
Cisco RPS 300
DC OUTPUT
1
2
3
4
5
6
STANDBY/A
CTIVE
STANDBY/A
CTIVE
OUTPUT PWR
TEMP
FAN
86676
1
1