3-7
Cisco AS5400 Universal Gateway Chassis Installation Guide
OL-2847-02 0A
Chapter 3 Installing the Cisco AS5400 and Cisco AS5400HPX Universal Gateways
Connecting to the Network
Connecting to a WAN
Warning
The telecommunications lines must be disconnected 1) before unplugging the main
power connector and/or 2) while the housing is open. To see translations of the warnings
that appear in the publication, refer to the
Regulatory Compliance and Safety Information
document that accompanied this device.
Warning
Hazardous network voltages are present in WAN ports regardless of whether power to
the router is OFF or ON. To avoid electric shock, use caution when working near WAN
ports. When detaching cables, detach the end away from the router first. To see
translations of the warnings that appear in the publication, refer to the
Regulatory
Compliance and Safety Information
document that accompanied this device.
Warning
This equipment is to be installed and maintained by service personnel only as defined by
AS/NZS 3260 Clause 1.2.14.3 Service Personnel. To see translations of the warnings that
appear in the publication, refer to the
Regulatory Compliance and Safety Information
document that accompanied this device.
Warning
To reduce the risk of fire, use only No. 26 AWG or larger telecommunication line cord. To
see translations of the warnings that appear in the publication, refer to the
Regulatory
Compliance and Safety Information
document that accompanied this device.
You can connect the universal gateway to a WAN in the following ways:
•
Use a breakout cable and straight-through RJ-45-to-RJ-45 cable for CT1 connections. (See
Figure 3-7
.)
Figure 3-7
Connecting to an RJ-45C (T1) Jack
30848
T1/E1 8 PRI
connector
RJ-45 jack
P1 P2 P3 P4 P5 P6 P7
P0
Straight-through
RJ-45-to-RJ-45 cable
