4-4
Hardware Installation Guide for Cisco 4000 Series Integrated Services Routers
OL-32185-02
Chapter 4 Configure Initial Router Settings on Cisco 4000 Series ISRs
Perform Initial Configuration on Cisco 4000 Series ISRs
no ip address
!
end
Step 10
Respond to the following prompts. Select [2] to save the initial configuration:
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
Enter your selection [2]:
2
Building configuration...
Use the enabled mode 'configure' command to modify this configuration.
Press RETURN to get started!
RETURN
The user prompt is displayed:
myrouter>
Complete the Configuration
When using the Cisco Setup, and after you have provided all the information requested by the facility,
the final configuration appears. To complete your router configuration, follow these steps:
Step 1
Choose to save the configuration when the facility prompts you to save the configuration.
•
If you answer ‘no’, the configuration information you entered is
not
saved, and you return to the
router enable prompt (
Router#
). Enter
setup
to return to the System Configuration Dialog.
•
If you answer ‘yes’, the configuration is saved, and you are returned to the user EXEC prompt
(
Router>
).
Use this configuration? {yes/no} :
yes
Building configuration...
Use the enabled mode 'configure' command to modify this configuration.
Press RETURN to get started!
%LINK-3-UPDOWN: Interface Ethernet0/0, changed state to up
%LINK-3-UPDOWN: Interface Ethernet0/1, changed state to up
%LINK-3-UPDOWN: Interface Serial0/0/0, changed state to up
%LINK-3-UPDOWN: Interface Serial0/0/1, changed state to down
%LINK-3-UPDOWN: Interface Serial0/2, changed state to down
%LINK-3-UPDOWN: Interface Serial1/0, changed state to up
%LINK-3-UPDOWN: Interface Serial1/1, changed state to down
%LINK-3-UPDOWN: Interface Serial1/2, changed state to down
<Additional messages omitted.>
Step 2
When the messages stop appearing on your screen, press
Return
to get the
Router>
prompt.
Step 3
Choose to modify the existing configuration or create another configuration. The
Router>
prompt
indicates that you are now at the command-line interface (CLI) and you have just completed a initial
router configuration. Nevertheless, this is
not
a complete configuration. At this point, you have two
choices:
•
Run the setup command facility again, and create another configuration.
Router>
enable