2-25
Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers
OL-1957-03
Chapter 2
Using the Setup Command Facility
Where to Go Next
Step 2
When the messages stop displaying on your screen, press Return to get the
2600>
prompt.
Note
If you see the next message, it means that no other AppleTalk routers were found on the
network attached to the port.
%AT-6-ONLYROUTER: Ethernet0/0: AppleTalk port enabled; no neighbors found
Step 3
The
2600>
prompt indicates that you are now at the command-line interface (CLI) and you have just
completed a basic router configuration. However, this is not a complete configuration. At this point you
have two choices:
•
Run the setup command facility again and create another configuration. Enter the following:
2600> enable
Password: password
2600# setup
•
Modify the existing configuration or configure additional features with the CLI as described in
Chapter 3, “Configuring with the Command-Line Interface.”
Where to Go Next
At this point you can proceed to the following:
•
“
Chapter 3, “Configuring with the Command-Line Interface,”
to learn how to use the CLI to
configure additional features.
•
The Cisco IOS software configuration guide and command reference publications for more
advanced configuration topics. These publications are available on Cisco.com, the Documentation
CD-ROM that came with your router, or you can order printed copies. For more information, refer
to
“Obtaining Documentation.”