4-5
VPN 3002 Hardware Client Getting Started
OL-2854-01
Chapter 4 Using the Command-Line Interface for Quick Configuration
Configuring the Private Interface
Note
If you do not change the private interface IP address, you cannot disable PAT mode. That is, you
cannot use Network Extension mode unless you configure a private IP address other than the default,
which is 192.168.10.1
Step 1
The system prompts you to configure the VPN 3002 private interface.
This table shows current IP addresses.
Intf Status IP Address/Subnet Mask MAC Address
-------------------------------------------------------------------------------
Pri Intf | UP | 192.168.10.1/255.255.255.0 | 00.90.A4.00.25.A8
Pub Intf | Disabled | 0.0.0.0/0.0.0.0 | 00.90.A4.00.25.A9
-------------------------------------------------------------------------------
DNS Server(s): DNS Server Not Configured
Default Gateway: 130.0.0.1
WARNING:-- The IP Address for the Private Interface is at the default value
WARNING:-- of 192.168.10.1. Keeping this Private Interface address will prevent
WARNING:-- Network Extension Mode from being enabled.
1) Configure the Private Interface
2) Skip the Private Interface Configuration
3) Back
Quick -> [ 2 ]
At the cursor, enter 1 Configure the Private Interface if you want to change the private interface
IP address or subnet mask. If you do not want to change the private interface address, accept the
default, 2, to continue with quick configuration. We assume that you enter 1.
Step 2
The system prompts you to enter an IP address.
This table shows current IP addresses.
Intf Status IP Address/Subnet Mask MAC Address
-------------------------------------------------------------------------------
Pri Intf | UP | 192.168.10.1/255.255.255.0 | 00.90.A4.00.25.A8
Pub Intf | Disabled | 0.0.0.0/0.0.0.0 | 00.90.A4.00.25.A9
-------------------------------------------------------------------------------
DNS Server(s): DNS Server Not Configured
Default Gateway: 130.0.0.1
> Enter IP Address
Quick Private Interface -> [ 192.168.10.1 ] _
To reconfigure the IP address for the private interface, at the cursor enter the IP address for the VPN
3002 private interface, using dotted decimal notation; for example, 192.168.12.34. Be sure no other
device is using this address on the network.
Step 3
The system prompts you for the private interface subnet mask. The entry in brackets is the standard
subnet mask for the IP address you entered above. For example, an IP address of 192.168.12.34
is a
Class C address, and the standard subnet mask is 255.255.255.0.
> Enter Subnet Mask
Quick Private Interface -> [ 255.255.255.0 ]_
To reconfigure the subnet mask for the private interface, at the cursor enter the new subnet mask, using
dotted decimal notation.
