![Cisco 1130AG - Aironet - Wireless Access Point Hardware Installation Manual Download Page 39](http://html.mh-extra.com/html/cisco/1130ag-aironet-wireless-access-point/1130ag-aironet-wireless-access-point_hardware-installation-manual_67803039.webp)
2-11
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
OL-6226-02
Chapter 2 Installing the Access Point
Mounting the Access Point on a Horizontal or Vertical Surface
Step 2
Drill a 3/16 in. (4.7 mm) hole at the X mounting hole locations you marked.
Step 3
Insert the wall anchors into the mounting holes.
Step 4
If needed, drill or cut a cable access hole (see
) large enough for the Ethernet and possibly the
power cables and pull the cables through the access hole until you have about 1 foot of exposed cables
protruding from the hole.
Note
You can optionally insert the Ethernet cable and the power cable (if used) through the cable
access notch in access point housing (see
Step 5
Position the mounting plate over the wall anchors or the drilled holes.
Step 6
Insert two 8 x 32 x 1 inch pan head screws in the X mounting holes and tighten.
To attach the access point to the mounting plate, see