VCC-SXCL3R
Rev.
905-0046-00
©2016 CIS Corporation. All rights reserved.
16
7.5.
Note for Trigger Shutter Mode
①
When the camera is initialized with trigger mode, dummy trigger signals shall be input 3times and more to
make the operation of CMOS stable.
②
At trigger shutter mode, if the next trigger is input with a timing to complete exposure within 3H after FVAL
became “L”, the camera may stop outputting its images. When the camera stops operating, or when proper
image data cannot be output, send “SRST” command to re-start the camera.
※
There might be a case when video out becomes black (black out).
TRIGGER
Exposure
FVAL
TRIGGER
Exposure
FVAL
③
At trigger shutter mode, please be carefully noted the reduction of exposure time when the next trigger is
overlapped.
Please refer to the Section 5. Function Settings, Note for Manual shutter control at normal shutter mode.
④
Do not input the next trigger during the exposure time with the timing as shown as (A) of Section 7.3.
Do not complete exposure of the next trigger while Reading out with the timing as shown as (A) of Section 7.4.
The next exposure can be started while reading out.
⑤
Do not change the output Tap at trigger shutter mode. To change output Tap, change the mode to normal
shutter mode first.
⑥
Ineffective lines would occur when exposure starts while outputting video at trigger mode. (Please refer to
Section 7.2. Vertical Sync Timing.
