CL-OPT200T/R
Rev.900-759-30-00
1.
Scope of Application
This is to describe CL-OPT200T/R signal converters enable CIS camera link cameras to connect with
frame grabber boards via optical fiber cables. All specifications contained herein are subject to
change without prior notice. Reproduction in whole or in part is prohibited.
2.
Handling Precautions
The signal converters must not be used for any nuclear equipments or aerospace equipments with
which mechanical failure or malfunction could result in serious bodily injury or loss of human life.
Our warranty does not apply to damages or defects caused by irregular and/or abnormal use of the
product. Please observe all warnings and cautions stated below.
Our warranty does not apply to damages or malfunctions caused by neglecting these precautions.
z
CL-OPT200T can be used only with CIS camera link cameras. Output CLK of CL-OPT200R is 81MHz
fixed. To capture the images, please use a frame grabber board corresponds to 85MHz.
z
Please use a metallic frame for heat dissipation. (The recommended size of the metallic frame:
larger than H:2mm W:90mm D:90mm)
CL-OPT200T/R Main Unit
CL-OPT200Fixing Bracket
z
Do not use
or store
the converter in the following extreme conditions:
¾
Extremely dusty or humid places.
¾
Extremely hot or cold places (operating temperature –5 to +4
℃
5 )
℃
z
Do not apply excessive force or static electricity that could damage the converter.
z
Follow the instructions in Chapter 6, “External connector interface” for connecting.
Improper connection may cause damages not only to the converter but also to the connected
devices.
©2013 CIS Corporation. All rights reserved.
3
