HopNet RS-232 Serial ModBus Radio
Connect the other end of the serial cable to the DIN rail serial adapter box.
Connect the end of the cable (RJ-45 connector) from the HopNet radio to the DIN rail
serial adapter box.
NOTE: Make sure the RUN/CONFIG switch is in the CONFIG position.
Connect power to the HopNet radio by plugging one end of the wall-mount power
supply into the serial adapter box and the other end into a wall outlet. A green LED
on the serial adapter box will turn on indicating power is present.
Set one HopNet radio to act as the base.
CAUTION: When using a USB to RS-232 adapter, the HN Wizard may not be able
to detect if the HopNet radio is disconnected from the computer. If the HopNet
radio is disconnected from the computer, it is necessary to click on the Restart
button on the HN Wizard screen. This will reload the settings from the radio in
case a different radio has been connected.
When using HopNet radio, one unit, and only one, must be set as the base. All other
HopNet radios must be set as remotes. With a HopNet radio connected to the PC,
start the HopNet Configuration Wizard program by double-clicking on the icon on the
desktop. The HopNet Configuration Wizard will automatically detect which serial
port the HopNet radio is connected to and its baud rate. When the radio has been
detected, the Continue button will appear.
©
2000- 2004 Cirronet
™
Inc
5
M-2410-0022 Rev B
