Circutor DCP-96 Vac, Instruction Manual

Page: 16 / 32

16
DCP-96 Vac
Instruction Manual
5�3�- THREE-PHASE NETWORK MEASURE WITH 3 WIRE
The
DCP-96 Vac
has 2 display screens in the three-phase network measurement system with a 3
wire connection, see
, Table 10
.
Use the keys and to browse through the different screens.
The display screens can change automatically depending on the time programmed in the section
“6.2.1.- CYCLIC DISPLAY
”.
The initial display screen, i.e. the first screen displayed when feeding the device or when exiting the
configuration menu, can be programmed in section
“6.2.3.- INITIAL DISPLAY SCREEN”
�
Table 10:Display menu: Three-phase network measuring with 3 wire�
Display menu: Three-phase network measuring with 3 wire
3800
L1-2
3801
3803
V
L2-3
L3-1
.
.
.
Phase-Phase Voltage (V)
5000
Hz
.
Frequency
(Hz)
If the input voltage value higher than a % of the nominal value, the device can make the digits on the
display start flashing, in the form of a light alarm. See
“6.2.5.- LIGHT ALARM”
Note: If a display screen shows
____
, check the programming of the transformation ratios.
____