3
READ THIS ENTIRE PAGE BEFORE PROCEEDING
FOR SAFETY OF PERSONNEL AND TO PREVENT DAMAGE TO EQUIPMENT, THE FOLLOWING
NOMENCLATURE HAS BEEN USED IN THIS MANUAL:
DANGER
Failure to observe precautions noted in this box can result in severe bodily injury or loss of life.
WARNING
Failure to observe precautions noted in this box can cause injury to personnel by accidental
contact with equipment or liquids. Protection should be provided by user to prevent accidental
contact.
CAUTION
ATTENTION
Failure to observe precautions noted in this box can cause damage or failure of equipment.
Non compliance of safety
instructions identified by
the following symbol
could affect safety for
persons:
Safety instructions where
electrical safety is
involved are identified by:
Safety instructions which shall be
considered for reasons of safe
operation of pump and/or protection of
pump itself are marked by the sign:
ATTENTION
ATTENTION
If operation of pump is critical to your business, we strongly recommend you keep a spare pump
or major repair kit in stock at all times. As a minimum, a minor repair kit (o-rings, gaskets, shaft
seal and bearings) should be kept in stock so pump refurbishment after internal inspection can
be accomplished.
CONTENTS
Seal Chamber Priming…………………………………………………………………………………..2
Safety and Table of Contents ...................................................................................................... 3
A. General Instructions .............................................................................................................. 4
B. Introduction ........................................................................................................................... 4
C. Description of Equipment ...................................................................................................... 4
D. Pump Model Identification ..................................................................................................... 5
E. Ordering Instructions ............................................................................................................. 5
F. Operation .............................................................................................................................. 6
G. Parts List and Noise Levels ......................................................................................... 7 thru 8
H. Pump Maintenance and Seal Drawing ....................................................................... 8 thru13
I. Troubleshooting .................................................................................................................. 14
J. Field and Factory Service and Parts .................................................................................... 14
K. Assembly Drawings ................................................................................................. 15 thru 18
