Circontrol Wallbox eHome CCL-eHOME Series, User Manual

Page: 10 / 16

08
WallBox eHome Series User Manual
3 — P R O X I M I T Y E R R O R
When the Charge Point is connected to the EV,
a Proximity short-circuit to earth may occur. Then, the status LED light bar turns
into red and flashes in a sequence of three blinks.
4 — N E G AT I V E P W M VO LTAG E E R R O R
• When the Charge
Point is connected to the EV, the PWM signal, used to communicate the Charge
Point with the EV, can be negative. Then, the status LED light bar turns into red and
flashes in a sequence of four blinks
5 — M A X I M U M O U T P U T C U R R E N T E R R O R .
If this on-board
current limit selection is not set up according to the hardware features, the
Charge Point detects it and shows this error. In this case, the status LED light bar
turns into red and flashes in a sequence of five blinks..
6 — T E M P E R AT U R E E R R O R
• When the Charge Point temperature is
below a certain value, it is detected by the Charge Point. In this situation, the status
LED light bar turns into orange blinking.In the meantime, if the Charge Point is
supplied with heater (optional), it starts heating the inside components until the
operating temperature is reached. Then the Charge Point starts charging again.
3
Blink Sequence
4
Blink Sequence
5
Blink Sequence