05
Before installation
Take into consideration this section before start wiring
connections of the Charge Point.
1 — E L E C T R I CA L P R OT E C T I O N S
Charge point may not include elements of electrical protection.
If this equipment has internal electrical protections, are installed in each
socket-outlet for the protection of the user against an electrical failure,
according to the international standard IEC 61851-1:2017.
In order to guarantee the total protection of the users and the installation
(power supply line included) in front of any electrical hazard, it is mandatory
to install a main circuit breaker (MCB) and a residual current device (RCD)
upstream of the charge point.
These electrical protections and the rest of the installation have to be
aligned with the local and national rules. The selectivity of the protections
has to be guaranteed at all times.
2 — P OW E R S U P P LY L I N E D I M E N S I O N I N G
The dimensioning of the input power supply line of the charge point must
be checked by a qualified electrician. Note that various factors such as
cable length between distribution board and charge point, maximum output
current of the charge point may have influence of the selected cable.
In such cases, increasing the cable cross-section it is required to adapt the
temperature resistance of the power supply line.
3 — M A X I M U M O U T P U T C U R R E N T
Please refer to the TECHNICAL DATA section to consult the default factory
settings from maximum output current of the charge point.
Depending on the model this value may vary.
B
Electrical wiring considerations
