4
Use FuzzyScan in PAIR Mode
Ensure the battery is fully charged. Please refer to the section of
Preparations before Using
for details.
Please choose your desired interface cable, then plug it into the host
interface port of the smart cradle and connect it to the host device.
Turn on the power of your host device.
Please note that if the scanner is shipped together with a smart cradle,
they are pre-paired already. You will see the link indicator of scanner
gives 1 blue blink per 2.5 seconds and the central indicator of smart
cradle turns steady blue. If the scanner and smart cradle just give
alternative red and green blinks
(“
Uninstall
” state), please follow step
5 to establish the connection between scanner and smart cradle.
Scan “PAIR mode” command. The status indicator of scanner will turn
steady red immediately.
Uninstall
PAIR
Mode
Place the scanner on the smart cradle, then you will hear one short beep
to indicate the pairing process is activated. The scanner will emit
continuous short clicks and the link indicator of scanner will flash blue
quickly during the pairing process. When you hear 4 beeps in ascending
tone, the pairing process is completed. You will see that the link indicator
of scanner gives
1 blue blink per 2.5 seconds
and the central indicator
of the smart cradle turns
steady blue
.
If the scanner pairing process failed or it’s not placed on the smart cradle
within 20 seconds, you will hear 2 “Di-do Di-do” beeps to warn the failure
of pairing, the scanner will return to uninstall state automatically.
Scan the corresponding host interface quick set command to complete
the installation.
The default host interface of smart cradle is preset to
USB HID
. If you
want to set the host interface to
USB COM
, you have to install the
USB virtual COM driver into your host device before using the
scanner. Please visit CINO website to download the driver
USB
PS/2
RS232
