Cino FuzzyScan F600BT Series, Reference Manual

Page: 75 / 87

W
ir
e
le
ss
F
u
z
z
y
S
c
a
n
R
e
fe
re
n
c
e
M
a
n
u
a
l
Configure Your FuzzyScan
68
Programming Procedure Programming Procedure Programming Procedure Programming Procedure
[Data Verifier]
Scan “Program” to enter the programming mode.
Scan “Verifier Control” and set bar code symbology to “ 48 ”
(Interleaved 2 of 5).
Scan “Identified Data Length” and set the length to “ 16 ”.
Scan “1st Identified Character” and set the identified
position to “ 00 ”, then set the identified character to “ 39 ”
(Hex Code of 9).
[Data Formatter]
Scan “Formatter Control” and set bar code symbology to
“ 48 ”.
Scan 1st Insertion” and set the identified position to “
06
”,
then inserted characters to “ 09 ” (Hex Code of TAB), “ 53 ”
(Hex Code of S), “ 4E ” (Hex Code of N).
Scan “2nd Insertion” and set the identified position to “
12
”,
then inserted character to “ 09 ”. In the final, you must scan
“ FIN ” (Finish) code to terminate this selection.
Scan “3rd Insertion” and set the identified position to “
16
”,
then inserted character to “ 09 ”. In the final, you must scan
“ FIN ” (Finish) code to terminate this selection.
[Data Replacer]
Scan “Replacer Control” and set bar code symbology
to “ 48 ”.
Scan “1st Replacement” and set the identified position
to “
00
”, then replaced character to “
41
” (Hex Code of
A).
[Data Organizer]
Scan “Organizer Control” and set bar code symbology
to “
48
”.
Scan “1st Organization” and set the identified position
to “ 16 ”, then set the data transmission to “ 0 ” (forward).
Scan “2nd Organization” and set the identified position
to “
17
”, then set the data transmission to “
1
”
(backward).
Scan “
END
” (Exit) to terminate the programming.
[Important Notice]
Please note that Condensed DataWizard will follow the
preset working flow as below:
Verifier Formatter Replacer Organizer
So when you set the identified position in Data Organizer,
you must consider the inserted data which you already set
via Data Formatter.