Projector-side configurAtion
R599864 - Assembly and Calbration User Manual
9
X-AXIS
Y-AXIS
Focused Not focused
Note that the Anamorphic lens focus will only change the focus on the x-axis. If the picture is not focus on
the y-axis, that means that the general focus is not correct. You may then set the global focus by adjusting
it directly from the projector, using the projector remote control.
3.0
PROJECTOR-SIDE CONFIGURATION
3.1 Configure the Picture Geometry for 2.35:1 Sources
Apply Anamorphic Mode A function:
When a 2.35:1 source is input and the Static Anamorphic Lens kit is mounted, you need to use the projector
“Anamorphic Mode A” to vertically stretch the picture and to obtain a full screen 2.35:1 image without distortion.
Browse into the projector menu, and apply the V-stretch function:
• Menu > Installation > Anamorphic Mode > Mode A
A faster way to operate this change is to configure a programmable IR-Remote Control or to use RS-232
commands to change Anamorphic modes.
3.2 Configure the Picture Geometry for 16:9 Sources
Apply Anamorphic Mode B function:
When selecting a 16:9 video source, the picture needs to be squeezed horizontally if the Static Anamorphic Lens kit
is mounted. To do so, you need to use the projector “Anamorphic Mode B” to obtain a without distortion a 16:9
picture into the 2.35:1 screen.
Browse into the projector menu, and apply the H-squeeze function:
• Menu > Installation > Anamorphic Mode > Mode B
Summary of Contents for Static Cinemascope Lens Kit
Page 11: ......
