19
EN
18
EN
Attention:
If your water softener is not performing as it should, please run through the check
list below.
Checklist
Solution
Page
Problem: Water runs from the drain
constantly.
Is the unit in recharge mode?
If yes, this is normal, wait until the recharge
is complete.
7
Is the power on?
There should be no fl ow to drain in the ser-
vice position.
8
Problem: Excessive salt usage.
Check the hardness setting.
Reduce the hardness if incorrect.
7, 16
Problem: Electronic Display.
The display shows error code: “Err
1“, audible alarm sounds, (see note
below).
Check all the connections are secure. Turn
the power off for 10 seconds then turn back
on, allow the system to reset.
13
OPTIONAL: The display shows error
code:“SALt“, audible alarm sounds.
The low salt alarm is active. Fill the brine
cabinet with salt. Pressing the [SET] key will
reset the salt alarm to full capacity of salt.
15
Is the digital display blank?
Check the power is turned on and all thecon-
nections are secure.
13
Problem: Unit regenerates at the wrong
time.
Is the present time correct?
Reset the present time.
7
Note:
If the home position
is not detected within 10 minutes
, the main display will show
an
“Err 1“ message
to indicate a controller error and an audible alarm will sound.
The error condition
can only be cleared by removing and re-applying the power.
Attention:
If problem persists, please call your local dealer or after sales service team.
7. Technical data
7.1 Cillit
®
Access 10 / 10 Bio*
Cillit
®
Access
Unit
10 / 10 Bio
Nominal connection (outside thread)
BSP
¾“ (DN 20)
Nominal fl ow rate in accordance with EN 14743
l/h
1440
Operating pressure EU (min./max.)
bar
1.0 / 8.0
Operating pressure UK (min./max.)
bar
1.7 / 5.0
Pressure drop down at nominal fl ow in accordance
with EN 14743
bar
1.0
Quantity of ion exchange resin
l
10
Nominal capacity (EN 14743) / (CaCO3 mmol/l)
m³x°dH/mol/ppm
26 / 4.6 / 460
Capacity salt reservoir
kg
12
Salt consumption per regeneration
kg
1.5
Water consumption per regeneration
l
85
Protection class
IP
51
Water temperature (min./max.)
°C
5 / 30
Ambient temperature (min./max.)
°C
5 / 40
Electrical connection
V / Hz
230 / 50
Dimensions: Width x depth x height (W x D2 x H)
mm
270 x 480 x 532
Connection height (A) / overfl ow height (S)
mm
403 / 270
Operating weight, approx.
kg
40
*Tested with HiFlow connection available in option
W
H
D
1
D
2
A
S
OPM - Cillit Access 10-25 vOrange - EN, DEv4.indd 18-19
02/10/2012 09:49