CID 11-20 GPM Series, Owner'S Manual

Page: 27 / 52

Standard & Heavy Duty Brush Cutters
January 2021
27
MAINTENANCE TASK
BEFORE
EACH
USE
WEEKLY YEARLY
Check skid steer loader hydraulic fluid level. Add
fluid as necessary.
Check that all fasteners (nuts, bolts,, washers, pins,
keepers) are in place. Tighten as necessary. (See
Bolt Torque Table on page 34)
Inspect and replace any worn, torn, or missing
safety decals.
Inspect hydraulic plumbing (hoses and connec-
tors) for damage or leakage. Repair or replace
hydraulic items as necessary.
Check condition of cutter blades. Sharpen or re-
place as necessary.
Check oil level in gearbox motor. Add fluid as nec -
essary.
Change oil in gearbox motor.
* Change oil after
50 hours of first time use, then every 1000 hrs or
yearly.
Wash Brush Cutter
• x
Check brush cutter for major scratches and dings.
Sand and repaint these areas to prevent rust
damage. *Use a paint formulated for farm equip-
ment which can be found at your local hardware
store .
X
X
X
X
X X X
X
X
X
X
4.2 Maintenance Schedule
This brush cutter attachment will provide years of dependable service if routine
maintenance procedures are performed. The maintenance tasks listed below
are based on normal operating conditions. More frequent maintenance may be
necessary with intense use or when operating in adverse environmental conditions.
Maintenance Log
Document all maintenance and service activities performed on this brush cutter using
the maintenance log included at the end of this manual.