EN-35
EREBA He
3.3 - Second step of
configuration: Parameter menu
According to the application of unit, several
parameters are to be configured to allow the
correct operation of system. The following
sections explain some standard cases of
installation. But to configure the unit, it is
necessary to access the parameter menu.
If there is no user interface on the unit, it is
necessary to use Customer communication
bus (Proprietary Protocol or Jbus) to
configure the unit. Otherwise in the case with
user interface, follow the next procedure.
3.3.1 - To access the parameter menu
If the user interface is in standby mode, press
one key to activate the WUI screen.
Press and hold the
Occupancy
key and the
Schedule
key simultaneously for 2 seconds.
The password screen is displayed.
Figure 11: Password screen
Enter the password:
0120
.
To change the number, press the
Up
or
Down
key.
or
To validate each number, press the
Schedule
key.
To validate the password and access
parameter configuration, press and hold the
Mode
key for 2 seconds.
3.3.2 - To navigate in the parameter
menu
a - First possibility
Press and hold the
Up
or
Down
key.
Select the Parameter Number with the
Up
or
Down
key. Scroll until the required parameter
is reached.
or
b - Second possibility
Press the
Up
or
Down
key until reach the
required parameter.
or
3.3.3 - To change a setting
Press and hold the
Schedule
key for 2
seconds.
In the next sections, four standard
installations are introduced, with for each
example a hydraulic scheme, electrical
connexion diagram and configuration steps.
To change the value of one digit, press the
Up
or
Down
key.
or
To validate each digit, press the
Schedule
key.
3 - INSTALLATION OF SYSTEM
Summary of Contents for Ereba He Series
Page 1: ...Instruction manual 05 2019 10195 Inverter Reversible Air to Water Heat Pumps EREBA He...
Page 94: ......
Page 95: ......
