５
Definition of Keypad Operation
Number
of N
Value
Control Object
Call No. N Preset Point
Set No. N Preset Point
51
Start Scan (low Speed)
Start Patrol
52
Start Scan (middle Speed)
Set Start Position of Scan
53
Supplementary Control of
dome
Start Scan (high Speed)
Set End Position of Scan
54
Power Supply of Camera
Power Supply On
Power Supply Off
55
BLC
On Off
56
Zero Illuminance
On
Off
57
Screen Display *
On
Off
58
D-Zoom On
Off
59
Focus Automatic
Manual
60
Iris Automatic
Manual
61
Automatic Manual
62
Interior Exterior
63
Mode of White Balance *
ATW One
Push
WB
64
Notes:
1. Those Items with “*” have memory function even the dome is switched off.
2. For those cameras with “menu”, you can use “Screen Display ON” to control the
Menu ON/OFF, and use “Screen Display OFF” to control Screen Display
ON/OFF.
3. For those cameras which have no “Zero Illuminance” or the function of “Zero
Illuminance” is automatically switched without control, then above “Zero
Illuminance” is invalid.
4. Notes to “Patrol” Function of the dome camera:
①
Automatically scan from no.1 to no.16 preset points one by one. If some
points do not have been preset or are cleared out after presetting, they will be
bypassed when patrol is carrying out.
②
The dwelling time between to preset points is 4 seconds.
③
The “Patrol” function of the dome camera can be carried out by presetting
no.51 position.
5. Notes to “Scan(auto pan)” Function of the dome camera:
①
The dome camera makes automatic scan between two specified positions.
②
The speeds of scan are divided into three levels. You can call no. 51, 52 and
53 preset position to start scan at speed of 1.5°/ sec, 5°/ sec and 10°/ sec
separately.
③
The dwelling time between the “Start Point” and “End Point” of scan is 3
seconds.
6. All notes mentioned above are supplementary descriptions under high speed. All original
operations of the control system are unchanged.
z
Settings of Communication Baud Rate of the dome Camera
