６
IV. Steps of Installation
1.
Mounting Base
2. Outer Tube
3. Shading Cover
4. Outer Cover
5. Camera
6. Connecting Cable
Dimension
Drawing
1. Carefully read the operation manual and the points for attention.
2. Carefully set the communication code, baud rate and address of the dome camera
and make confirmation they are correct.
3. Take out the plug of the dome camera and connect external power supply, RS485
and video wires as per marks on the plug. Take care that the power supply of the
dome camera is DC12V/1.2A and adopt the particular power supply which is
provided with the dome camera.
Red : DC12V+
Black : GND
Orange : RS485+
Yellow : RS485-
VIDEO
.
4. Take out the mounting base from the spherical camera, thread the connecting
wire from behind through the central hole of the base. Fix the base by three
screws on the ceiling as per the drawing, and connect the wire with the ball. Aim
the latch in the ball with the notch on the base as per the drawing, and mount the
ball upward to the position and turn it clockwise until the spring sheet on the
base takes effect. In case the wire could not come out from behind the ceiling,
you can open a hole on the edge of the casing for running of the wire.
Coding Switch
Baud Rate
1 2 3 4 5 6
2400 bps
OFF
OFF
4800 bps
ON
OFF
9600 bps
OFF
ON
19200 bps
ON
ON
