07
08
Positioning of Panel
Place on the table. For best reception of the wireless signal, it is recommended that
you place the panel in an open area that is located centrally to the whole alarm system.
Avoid placing the panel on a load-bearing wall or beside any electrical appliances.
Set on the Table
After closing the back cover of the panel and tightening the screws, it can be placed
on the table for use.
Use of Accessories
Remote Control
Arm button
Disarm button
SOS button
Home Arm button
Description of Indicator Light
Buttons
Status
Press Arm button and the panel will make a
“Di”
sound once, setting the
system to Arm.
Press Arm button for at least 3 seconds, the indicator light goes on.
The system will be set to Mute Arm.
Press Disarm button and the panel will make a
““Di”
sound twice, setting
the system to Disarm.
Press Disarm button for at least 3 seconds, the indicator light goes on.
The system will be set to Mute Disarm.
Press Home Arm button and the panel will make a
“Di”
sound once,
setting the system to Home Arm. Under this condition, home zone
accessories will be set to Disarm to enable home activities of the owner.
Press Home Arm button for at least 3 seconds, the indicator light goes
on. The system will be set to Mute Home Arm.
Press SOS button, the indicator light goes on. The panel will immediately
sound the alarm.
Note:
If, upon pressing a button, the LED light flickers twice and then goes out, then the
remote control battery is low. Please replace the battery as soon as possible.
