Chrysler 300M 1999, Manual, Page: 573 / 766

TEST 2A
REPAIRING ALL DOORS FAILING TO LOCK AND UNLOCK FROM ANY SWITCH
Perform TEST 1A Before Proceeding
*Perform Verification TEST VER-2A. **Check connectors - Clean / repair as necessary.
WITH THE DRB ENTER
"BODY COMPUTER" DO THE DOORS LOCK NO PERFORM TEST
START TEST 2A. THEN "ACTUATORS" DURING ACTUATION? 2B.
AND ACTUATE THE
DOOR LOCK RELAY.
YES
WITH THE DRB ENTER
STOP THE "SENSORS" AND READ IS THE VOLTAGE YES PERFORM TEST
ACTUATION. THE DOOR LOCK ABOVE 0.2 VOLTS? 2C.
SWITCH VOLTAGE.
NO
IS THE VOLTAGE
WITH THE DRB, READ PRESS THE DOOR ABOVE 1.7 VOLTS YES REPLACE THE BODY
THE DOOR LOCK LOCK SWITCH TO THE WITH THE SWITCH CONTROL MODULE.*
SWITCH VOLTAGE. LOCK POSITION. PRESSED?
NO
DISCONNECT THE RIGHT
REMOVE THE RIGHT DOOR LOCK SWITCH
FRONT DOOR TRIM HARNESS CONNECTOR.**
PANEL.
FIG. 1
WITH A VOLTMETER,
MEASURE THE FUSED
IS THE VOLTAGE NO REPAIR THE OPEN
B (+) CIRCUIT. ABOVE 10.0 VOLTS? FUSED B (+)
CIRCUIT.*
FIG. 1
YES
KEY OFF. WITH AN
OHMMETER, MEASURE IS THE RESISTANCE NO REPLACE THE RF
BETWEEN GND AND THE BELOW 5.0 OHMS? DOOR LOCK SWITCH.*
THE RF DOOR SWITCH
MUX CKT. FIG. 1
YES
CONTINUE TEST
2A ON THE NEXT
PAGE.
P
O
W
E
R
D
O
O
R
L
O
C
K
S
Y
S
T
E
M
563