Chrysler 2007 Sebring Sedan, Instruction Manual, Page: 118 / 376

training process. Some garage door openers may require
you to do this procedure a third time to complete the
training.
Canadian Programming/Gate Programming
Canadian radio-frequency laws require transmitter sig-
nals to
⬙
time-out
⬙
(or quit) after several seconds of
transmission, which may not be long enough for
HomeLink to pick up the signal during programming.
Similar to this Canadian law, some U.S. gate operators are
designed to
⬙
time-out
⬙
in the same manner.
If you live in Canada or you are having difficulties
programming a gate operator by using the
⬙
Program-
ming
⬙
procedures (regardless of where you live), replace
ⴖ
Programming HomeLink
ⴖ
Step 3 with the following:
3. Continue to press and hold the HomeLink button
while you
press and release your hand-held transmitter
every two seconds until the frequency signal is accepted
successfully by HomeLink. The Universal Transceiver
light will flash slowly and then rapidly when the pro-
gramming is successful. Proceed with
ⴖ
Programming
HomeLink
ⴖ
Step 4 to complete the procedure.
NOTE: When programming such a garage door opener
or gate, unplug the device to prevent possible damage to
the garage door or gate motor.
Using HomeLink
To operate, simply press and release the programmed
HomeLink button. Activation will now occur for the
trained device (i.e. garage door opener, gate operator,
security system, entry door lock, home/office lighting,
etc.). The light in the display shows that the signal is
being transmitted. For convenience, the hand-held trans-
mitter of the device may also be used at any time.
Erasing HomeLink Buttons
To erase programming from the three buttons (individual
buttons cannot be erased but can be
⬙
reprogrammed
⬙
-
note below), follow the step noted:
Press and hold the two outer HomeLink buttons (for
approximately 20 seconds). Release the buttons when the
indicator begins to flash rapidly. All three channels will
be cleared.
118 UNDERSTANDING THE FEATURES OF YOUR VEHICLE