English
–
V.202106
USB and Ethernet Stand Alone interface
7
Datasheet / Technical manual
LED Display Menu Key
The LED Display shows the current scene, zone, page, colour, operating mode, speed, dimmer and firmware version. The
displayed values vary according to the selected mode.
PC
-
The interface is connected to a computer and communicating with the software. In this mode, the
interface is under software control.
IP
-
The interface is in stand-alone and static IP mode. The default network address is 192.168.0.5.
dh
-
The interface is in stand-alone and DHCP mode. The network address is automatically defined by
the router or the access point.
SA
-
Scene trigger mode. In this mode, the LED display shows the current scene number (from 01 to
511). By default, when no scene is playing, all DMX channels are set to 0.
“
00
”
indicates Blackout
and the interface sends nulls (0x00) on all DMX channels.
PA
-
Page mode. There are 10 pages of 8 scene, it is about 80 scenes maximum to be triggered. The
display indicates the page number from P0 to P9. In this mode, use the 8 trigger buttons play the
scenes stored in the selected page.
Co
-
Colour mode. The display indicates the selected custom colour number (from C1 to C8). Or the
colour value applied from the colour wheel.
SP
-
Speed mode. Increase or decrease the current scene speed. The display indicates the speed of
the current scene from -9 to 9.
dI
-
Dimmer mode. Increase or decrease light output of scenes and custom colours. The display
indicates the general intensity from -9 to 9.
Pr
-
Programming memory Mode. Pr is displayed when the interface is writing a show to memory.
Zo
-
Zone mode. After programming the interface memory, Zone A is selected by default. In this mode,
the LED display shows the current Zone: Global, A, B, C, D, E.
Zone A to D display :
Global Zone display :
The display switches between the current zone and the running scene number every 3 seconds.
Use + or
–
to navigate between zones. Scene buttons may be pressed to instantly trigger scenes
without entering in the zone with the
button.
F1, F2, F3 -
Functions 1 ~ 5 of the advanced function mode.
No
-
Node mode. (Art-Net decoder)
Ar
-
Art-Net mode (Stand Alone)
AC
-
sACN mode (Stand Alone)
YE
-
Year setting in the clock setting mode.
Mo
-
Month setting in the clock setting mode.
dA
-
Day setting in the clock setting mode.
ho
-
Hour setting in the clock setting mode.
Mi
-
Minute setting in the clock setting mode.
CL
-
Confirmation of the new clock setting.
bL
-
Updating firmware mode. Displayed when a new firmware is being written to memory.
The display will flash during the firmware update. Do not disconnect the interface in this mode.
Advanced device configuration
The advanced function mode menu provides access to several global interface settings. Press and hold the
button for
4 seconds to enter this mode.
F1: Display the static IP of the interface. Press
to scroll through the numbers.
F2: Select DHCP (dh) or static IP (iP) mode. Press
to activate the selected mode.
F3: Use the + and - buttons to select the Stand Alone (SA), Art-Net (Ar), sACN (AC) or Node (no) mode. Press
to
confirm the selected mode. The interface will immediately reboot to activate the new mode.
F4: Manual Clock Setting. Press
to enter this mode. (See Clock and calendar setting below).
F5: Display the interface firmware version. Press
to scroll through the numbers.
