Installing and
configuring the Remote
Power Supply Rack
Shelf
Use the following instructions to install and configure the Remote Power Supply Rack Shelf external
power supply.
Mounting the Remote Power Supply Rack Shelf
The power system must be mounted in a clean and dry environment. Sufficient free space must be
provided at the front and rear of the power system.
Warning! If not avoided, the following could result in death or serious injury.
•
This product must be installed within a restricted access location not accessible by the general
public.
1. Find a location in the rack for a 3U device.
2. Attach the Remote Power Supply Rack Shelf to the rack.
To ensure a proper electrical bond between the system chassis and the relay rack use thread-
forming mounting screws and star washers.
Inserting the power modules into the Remote
Power Supply Rack Shelf
The power modules, or rectifiers, convert an AC power source into the DC current required by the
product.
1. Remove the cover from the rectifier slot.
2. Slide the power module into the front of the chassis until it clicks into place.
3. To lock the power module, lift the handle and snap it into place.
4. Repeat steps 1 to 3 for each rectifier in the Remote Power Supply Rack Shelf.
Remote Power Supply Rack Shelf Installation and Setup Guide
8
020-102093-03 Rev. 1 (04-2018)
Copyright
©
2018 Christie Digital Systems USA, Inc. All rights reserved.